eyYvxmep 304 Stainless Steel Cable Tie Buckle 19mm No ML Type Flower Buckle Winding Cable Tie Packing Tooth Buckle Joint

Show on Amazon

Offer

Product description

  • 3. Make a circle around the object to be bundled, and the other end goes through the buckle and leaves a section.4. Tighten the cable tie with cable tie pliers and bend it in reverse. 5. Cut off the cable tie and use a hammer to hammer the buckle ears tightly. 6. The installation is complete.
  • 3.Wrap around the object to be bundled, and the other end goes through the buckle and leaves a section. 4.Tighten the cable tie with cable tie pliers and reverse bend.
  • L type use steps 1.Measure the length of the bundled object plus about 15cm per week, cut a section of stainless steel strip and bend one end by 1-2cm. 2.The wire mouth of the buckle is against the bending direction and penetrates into the tie.
  • 5.Cut off the cable tie and tighten the buckle ear with a hammer. 6.Installed.

You might also be interested in these cables tie type buckle.

© 2025 WHICH.ONE. ALL CONTENT IS SUBJECT TO OUR COPYRIGHT.