End Feed Wall Plate Elbow 15mm x 1/2", 1 in Pack

Show on Amazon

Offer

Product description

  • End feed capillary fitting is part of the Made4trade range and manufactured to BS EN 1254-1. This fitting joints copper tube manufactured to BS EN 1057 using solder. It is suitable for above ground hot and cold domestic or potable water services, central heating systems, low-pressure steam heating and pressurised unvented heating systems.
  • It is equally suitable for sanitation services and compressed air lines, gas distribution systems for natural and manufactured gases. A solder joint is created through the principal of capillary action, when the fitting and tube is assembled and heated to the appropriate temperature,
  • solder becomes molten and is drawn into the gap between tube and fitting for a durably reliable joint. It is recommended soldering flux is also used to aid in this. Only available in 22mm x 1" size. Plumbing Solder available 11150. Plumbing Flux available 73706 & 21961
  • Manufactured from copper For use on hot and cold water systems Neat, tidy installation when installed by an experienced fitter System covers all aspects of gas and heating systems in domestic and light commercial applications
  • Fitting type Elbow, Diameter (mm) 15mm, Pack Size 1
  • Angle (degrees) 90, A Size 15mm, B Size 1 2", Equal or Reducing Adapting

You might also be interested in these wall plates elbow 15mm.

© 2025 WHICH.ONE. ALL CONTENT IS SUBJECT TO OUR COPYRIGHT.