IP68 DCDC 40A Charger with MPPT for 12V LiFePO4, Lead-Acid, SLA, Gel, AGM, Cal, Waterproof Battery Charger with Anderson Dual Input and One Output, Multi-Stage Charging for RV Camper Trailer Boat

Multi-input for Battery Charging Renogy DC-DC On-Board Battery Charger is designed to charge service batteries from a starting battery linked to an alternator, or by utilizing solar panels connected directly to the unit, offering multiple charging options and ensuring your battery stay fully charged. Compatible with multiple deep cycle battery types AGM, GEL, Flooded, and Lithium

Recommended to Match with 40A ANL Fuse The Renogy ANL fuse will protect your controller, wire, and battery from overcurrent.

Monitoring Screen Stay informed about your house and auxiliary battery's charging status and easily monitor the solar system's overall health.

Multi-input for Battery Charging Renogy DC-DC On-Board Battery Charger is designed to charge service batteries from a starting battery linked to an alternator, or by utilizing solar panels connected directly to the unit, offering multiple charging options and ensuring your battery stays fully charged. Compatible with multiple deep cycle battery types AGM, GEL, Flooded, and Lithium.

Compatible Multiple Battery Types Compatible with a multitude of alternator types, the DC-DC battery charger offers correct charging for AGM, Flooded, Gel, and Lithium batteries.

Compatible Multiple Battery Types Compatible with a multitude of alternator types, the Renogy 12V DC to DC charger offers correct charging for AGM, Flooded, Gel, and Lithium batteries.

Multi-input for Battery Charging This on-Board Battery Charger is based on multi-phase synchronous rectifier technology. The charging working modes divides into PV charges service battery, alternator charges service battery, PV and alternator charge service battery and PV charges starter battery.

SUITABLE FOR 12V OR 24V vehicle systems, the unit will also work with either standard or variable smart alternators.

Blue

Protect Your Starter Battery The DC-DC battery charger is capable of identifying whether the generator is started, to prevent over-discharge of the starting battery and protect the generator.

Intelligent charging protection protection against overvoltage at the input, protection against reverse polarity at the output, protection against overvoltage of the battery, protection against over-temperature, protection against charging time out and BMS protection (for LFP battery).

Compatible with a variety of different batteries- Gel, LiFePO4 Lithium, AGM and Flooded batteries can all be properly and effectively charged by the Vixen Go DC to DC charger. Input DC Battery 12.5V-16.0V, Solar 16.0V-25.0V

Blue

Automatically detect 12V or 24V DC system voltages innovative mppt technology with High tracking efficiency up to 99% and peak. Conversion efficiency of 98%.

This 30a charge controller compatibility with 12V 24V system.Fully 4-Stage PWM charge (Boost, ABS, Equalization,Float),the power MOSFET is used as and electronic switch without any mechanical switches and equipped with industrial-grade STM 8 microprocessor to prolong your battery life cycle.

Dual Battery Monitoring Stay informed about your house and auxiliary battery's charging status and easily monitor the solar system's overall health

Easy to Install and Operate The charge controller should connect the battery first, then the solar panel, and finally the load! The disassembly sequence is contrary to the wiring order.Dual mosfet Reverse current protection, low heat production. ( Note The charge controller will heat up when it is running. Please be careful to install the charger controller on a flat, well-ventilated place)

Wide Compatibility The solar charger controller with 30A rated discharge current is compatible with 12V or 24V system automatically, suitable for lead-acid batteries OPEN, AGM, GEL. Dual USB 5V 3A output ports support mobile phones, tablet PCs or other devices that require 5V voltage.

Boasts an outstanding 93% efficiency, along with an adaptive automatic 7-stage charging process to deliver faster and more efficient charging, whilst maximising the lifespan of the battery.

WIDE APPLICATIONS This 12V MPPT solar panel controller module has a wide range of applications, which can be used for 18V 12V 9V solar battery charging, car battery charging, mobile phone speakers, electric chargers, UPS, portable industrial equipment.