Vortice 12221 Quadro Super T GB Centrifugal Extractor Fan with Timer

centrifugal extractor fan

IPX4 splashproof. Class II double insulated

Centrifugal suction for Vortice square ducts

Extraction rate 70.8 (high speed) 50 (low speed) litres per second, 255 (high speed) 180 (low speed) cubic meters per hour

A quiet and efficient fan, providing excellent low energy and noise performance. Ideal for modern bathrooms and toilets. This model is for operation with the room light switch. When the light is switched on the fan comes on, when the light is switched off the fan continues to run for a pre-set time. Requires permanent live, switched live and neutral (3 wires excluding earth) at the fan position in order to operate correctly

This model is designed for simple switching on off from a separate switch, e.g. light switch or spur unit (not supplied). It does NOT have a run-on timer.

Continuously running central extract unit

Dimensions 152mm wide x 152mm high x 116mm deep (visible beyond installed surface). Spigot is 96mm diameter and extends for 25mm. This fan is for connection to 100mm 4" ducting.

Data, Safety and Performance Certified by IMQ Performance. CE Mark

Extraction rate 22.2 litres per second, 80 cubic metres per hour

Suitable for remote environmental sensors of Temperature, Relative Humidity, Smoke and Presence.

Centrifugal Extractor Fan. Mains voltage 230 240V AC 50Hz

Mains voltage 230 240V AC. Power consumption 6 - 25 watts (low high). Continuous running in accordance with ADF System 3. Trickle and Boost speed options

This model incorporates a run-on timer which operates in connection with the room light switch. When the light is switched on the fan starts, when the light is switched off the fan continues to run for the pre-set period. Permanent live, switched live and neutral wires (3 cores + earth) are required at the fan position in order to function correctly.

Mains voltage 220-240V AC 50Hz. Two speed options, selectable at installation

Back Draught Shutter. Can be mounted on wall or ceiling.

Used to connect to an extractor fan in your bathroom or shower room when the duct passes through your loft or attic. In this situation warm air being extracted by the fan can condense due to the cold air above and result in water droplets coming back down into the extractor fan and possibly damaging it. Using this type of ducting normally solves the problem as the insulation on the duct means that the air passes through without coming into contact with the cold temperature above.

Dimensions See picture 2

Mains voltage 220-240V AC 50Hz. Power consumption 25 watts

2 Year Warranty