ElecGear Replacement Joysticks (EL3 ALPS) Compatible with Nintendo Switch Pro and PS3 Wireless Controller, Analog Controller, Joystick Module (4 Pack)

Product description

• EL3 for Switch Pro Controller - 4 replacement analog joysticks work with Nintendo Switch Pro and some PS3 controllers. The key module was manufactured by ALPS. This series of RKJXV controllers comes with 10K mower potentiometers
• COMPATIBILITY This version of analog key comes in dark grey bottom plate with two plastic sticks inserted into the PCB. It locks in 3 directions when not sitting in the controller cover. Pot resistors can be green or black. It is widely used in Switch Pro controllers. Some have reported that it is also used in SNES 8Bitdo controllers
• Extra resistance complicated movement mechanism and daily wear and tear finally caused drift. Even the new sensors cannot be 100% balanced. Calibration in controller settings may not work. We packed 10 correction resistors to solve the potential hardware problem. Solder one or two small parallel resistors to the potentiometer in the opposite direction against the drift. It will help correct the drift of 3-5 degrees
• WHEN TO REPLACE - The analog joystick needs to be replaced when your controller has the problem of drift, crawling, stuttering, blind spot, dead spot, dead zone, no reaction when clicking, or it won't center after years of wear. Original repair parts ensure accuracy and extend service life
• Operation Reminder - With up to 14 pins, desoldering and soldering the whole module takes serious skills. Professional repair with a heat gun is recommended. You can simply replace the side potentiometer sensor alone to solve most joystick problems